First off, you MUST have BIND 9.x or later compiled and installed.  You
need the lwres libraries and bind libraries (and include files) and you
will also need lwresd.  Once you have it compiled and installed, try running
lwresd.  On solaris I had to use the -i flag to specify where to write
the pid file, and on linux I didn't. (shrug) Go figure. But you gotta get
lwresd running before moving on. Don't panic, this is FAR easier to get
going than a full-blown BIND server (grin).

Building bulkquery

First, edit the Makefile and uncomment out the section of CC, CFLAGS, and
LDFLAGS settings for your operating system and set DESTDIR to the directory
you want to install it in.

Then, edit bulkquery.c and edit the MAXTHREADS and DEFTTL values. You probably
don't need to fiddle with anything else and the defaults for MAXTHREADS and
DEFTTL should be fine.

MAXTHREADS is the maximum number of threads you will spawn.  The more you
spawn, the harder you will work your DNS server (and the RBLs) and the
more resources you'll use up on your own machine -- AND the faster the 
queries will complete. If you set this too high your operating system might
not permit bulkquery to run. The default of 50 works fine on Solaris and
and Linux.

DEFTTL is the default time to live value.  This is sort of a misnomer, since
the REAL time to live values will be obtained in the replies for queries
that were found. But for the queries that were NOT found, DEFTTL will be
used. This is so that the non-existence of an IP in one of the RBLs will be
cached by the filters plugin for DEFTTL seconds.

After looking at bulkquery.c, just run "make" to compile it.  If it compiles
without errors, you can run "make install" (you may need to be root to
write to DESTDIR).  You can test it with the included sample input file
bq.in

If all you get back are entries with the default TTL value (ie. 7200), then
something isn't working.  Make sure you have lwresd running. You should also
make sure the machine you're running it on CAN make DNS queries (grin). So
check your /etc/resolv.conf file (on UNIX machines anyway).  I'll include
the file bq.out to show what the output of bulkquery looked like at the time
of this writing (assuming everything was working).